UART RX Start-Bit Detector
Detect the beginning of an incoming UART frame.
Task
While idle, detect the serial line going low and assert a one-cycle `start_seen` pulse so the receiver can begin timing the frame.
Examples
- rx=1 → receiver stays idle
- rx changes from 1 to 0 → start_seen=1 for one cycle
Constraints
- Register the previous RX level.
- Reset initializes the previous value to idle-high.
- Do not repeatedly pulse while RX remains low.
What this problem is testing
A strong answer translates the requirement into synthesizable state and combinational logic, states reset and update semantics precisely, and handles boundary conditions rather than only the nominal case.
Interview habit: before coding, state reset behavior, the state that must be stored, and the conditions that update each output.
Verification plan
- Check reset or initialization before normal operation.
- Exercise the nominal sequence cycle by cycle.
- Test boundaries such as zero, maximum count, wraparound, full/empty, or simultaneous controls when they apply.
- Prove the design holds state when an enable or qualifying condition is absent.
Edge cases worth testing
- Back-to-back frames.
- Start/stop timing and LSB-first ordering.
Common mistakes
- Incomplete combinational assignments that infer a latch.
- Blocking/non-blocking assignments that do not match combinational versus sequential intent.
- Parameter-width and boundary errors.
- Passing the happy path while missing reset, overflow, simultaneous operations, or illegal requests.
Interview follow-up questions
- How would you parameterize this design without introducing width or boundary bugs?
- What changes if reset timing or polarity changes?
Concepts to review
UART, receiver, edge-detect
Open UART RX Start-Bit Detector in the HDLForge interactive editor.
Related problems
- 2:1 Multiplexer — Easy
- Parameterized Counter — Easy
- Priority Encoder — Medium
- Synchronous FIFO — Hard
- Shift Register — Easy
Explore the RTL Design Practice & Interview Preparation hub.